Large stamps through a Stencil

For my last sample with the new Doodleology stamps from Claritystamp, I decided to use small sections of the stamps and matching stencil through a second stencil.

Attach the Framework Squares stencil to a piece of Clarity 7” x 7” stencil card using masking tape to create a hinge at the top.

Add the doodleology square stencil below and pounce Blueprint Sketch Distress oxide through both stencils in the bottom right corner.

Remove and clean the doodle stencil.

Replace it below the middle left hand square and pounce Salty Ocean Oxide through both stencils.

Repeat with Stormy Sky Oxide in the top middle square, this time laying the doodle stencil over the top of the framework one.

Cover the inked sections with a stencil inner from the Framework stencil set. Mask off three more squares in the same way.

Leaving the large Doodleology square stamp on the acetate, ink up one corner in Smoky Grey Versafine ink. Press firmly into the bottom left square of the Framework stencil.

Ink up a separate area of the same stamp in Majestic Blue Versafine ink and add stamping into the centre square in the same manner.

Finish by stamping into the top right corner with Deep Lagoon Versafine ink. Mask off the finished squares.

Add stamping into the remaining squares using the long doodle stamp from the same set in the same colours of ink.

Trim back the stencil card to 6.75” x 6.75” by removing a small amount from each side. Mat onto the front of a 7” x 7” black card blank.

To finish, add some of Barbara’s word stickers.